Missouri Whitetails - Your Missouri Hunting Resource banner
1 - 5 of 5 Posts

·
Registered
Joined
·
791 Posts
Discussion Starter · #1 ·
I'm a little concerned about all the 90 degree angles I'll have when I run the 1 1/4" pipe from water tank to the pump inside. Will effect the pumps ability to pull the water from the tank, or the suction? See diaghram, and pump specs...

In advance, I appreciate the guidance. This is the last thing I have to do, and I'm done, or 90 percent done with the hunting cabin. :cheers:

[file]7845[/file]
 

·
Registered
Joined
·
6,357 Posts
I will be honest with ya, I cant say for sure but I printed this out and gonna check with a pump rep ,your getting into engineering on me now :D I should get some info by tommorow
 

·
Registered
Joined
·
6,357 Posts
Its not the 90s so much that I am concerned with but the amount of Head you have( 13+ foot) on a 1/2 hp moter,not sure if your gonna maintain 40-60 psi,it may not make a difference when your on the suction side of the pump as it does on the discharge but I want to make sure for ya
 

·
Registered
Joined
·
791 Posts
Discussion Starter · #5 ·
The pump and tank are Sears brand, but made by Flotec. It's a great price, in fact, so good that they're back ordered. I wish it was a 3/4 hp versus a 1/2 hp. A good setup for what I need it for.....fingers crossed.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top