Missouri Whitetails - Your Missouri Hunting Resource banner
1 - 3 of 3 Posts

·
Registered
Joined
·
5,538 Posts
Discussion Starter · #1 ·
http://www.rifle-accuracy-reports.com/AccurizedAction.html

in this article they use a Rem 700 action but the process is the same for a winchester or what ever you decide on. you wonder why those accurized actions cost so much, lot's of time put into them. we don't need this for minute of deer mind you but for those who just always wonder what it would take to build a real tack driver, here's your start.
 

·
Registered
Joined
·
5,538 Posts
Discussion Starter · #3 ·
:cheers: not meant to be a definitive "How To" just a good representation/explaination of what is truely involved.
 

·
Registered
Joined
·
5,538 Posts
Discussion Starter · #5 ·
glen over on 24hrcampfire they were talking about the need for remintons to have a bolt bushing placed for proper fireing pin alignment as well. it seems their (reminton) over all quality control is not what it once was.

here is the one reply in the thread were the guy explains it

The "cratered" or flowed primers can allow primer shard material to eventually build up enough to not allow the bolt to ****.
In addition, the firing pin on many/most 700's, in particular on the .378" bolt face, is not adequately supported behind the face of the bolt, hence it can & does slap the side of the hole when fired, allowing the possibility of irregular firing/lock time. Blown primers at low pressures are also a fairly common malady.

he then gives this link for a fix
http://www.gretanrifles.com/bushfiringpin.asp

your experiances with this? i am not remington savey so this is more of a learning session for me
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top