Rod Holders?

Discussion in 'Fishing General' started by oneshot 1, Aug 11, 2017.

  1. oneshot 1

    oneshot 1 Active Member

    Jun 11, 2003
    Ozarks
    Ok in the past I use Rebar with 2 inch PVC Pipe strapped to it for Rod Holder. This has always worked well but they were close to the ground which I can no longer do.

    Will longer Rebar about waste high sticking out of the ground work or will Fish just pull it out?

    oneshot
    :D The Big Grin would just throw a Long Line with bunch of Hooks on it out.
     
  2. BackyardBandit

    BackyardBandit Don't mind me

    Jan 12, 2012
    West St. Louis Co.
    If it's thick enough and deep enough it will get the job done well.:innocent:
     
    huntintail likes this.

  3. bluecan

    bluecan Long time listener, first time caller

    I'm sure he knows that, he was asking about rod holders.....
     
    huntintail and jehrbo like this.
  4. oneshot 1

    oneshot 1 Active Member

    Jun 11, 2003
    Ozarks

    Ok slow today. Leaves me out on all counts.

    oneshot
    :D :eek: THE BIG GRIN IS GOING TO TELL MOM!!!!!
     
  5. Steelman

    Steelman Active Member

    Dec 29, 2009
    Just use 2" PVC pipe about 5' long and a rubber mallet to drive it in the ground, should work fine.
     
  6. DougC

    DougC Active Member

    Dec 1, 2008
    Independence
    I always used angle iron clamped to the pvc with the end cut to a point. Stand them almost straight up and your rod isn't going anywhere-as long as you're paying attention!
     
  7. Mailman

    Mailman Well-Known Member

    Feb 2, 2005
    Blue Springs Mo
    Just duct tape your rod to your wrist...and brace yourself for the strike. :cool2:
     
  8. oneshot 1

    oneshot 1 Active Member

    Jun 11, 2003
    Ozarks
    Funny I have set there half asleep holding a Rod until Fish Hits.

    Usually let them pull until it looks like they could pull it in. Medium Heavy Rod with 30# Test Line.

    oneshot

    :D The Big Grin could kiss her tail good bye.